Cisco Cisco Intelligent Automation for Cloud 4.0 Technical Manual
Add New Action Buttons in My Servers
Document ID: 117659
Contents
Introduction
Before You Begin
Requirements
Components Used
Adding New Buttons to My Server
IAC and Service Designer
Adding a New Button
Related Information
Before You Begin
Requirements
Components Used
Adding New Buttons to My Server
IAC and Service Designer
Adding a New Button
Related Information
Introduction
This document explains how to add a new button in My Servers popover and bind it with a new service.
Before You Begin
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on these hardware and software versions.
The following configuration applies to IAC versions 4.0.
•
Adding New Buttons to My Server
Creating a new service or modifying an existing service is beyond the scope of this document.
IAC and Service Designer
The procedure for creating new buttons in My Servers requires the use of Service Designer.
Adding a New Button
The following example illustrates the steps for adding a new button to "Release Floating IP Address."
Step 1: Go to Service Designer as shown below in Diagram 1.