Cisco Cisco Intelligent Automation for Cloud 4.0 Technical Manual

Page of 4
Add New Action Buttons in My VDCs
Document ID: 117662
Contents
Introduction
 Before You Begin
      Requirements
      Components Used
 Adding New Buttons to My VDC
      IAC and Service Designer
      Adding a New Button
 Related Information
Introduction
This document explains how to add a new button in My VDC popover and bind it with a new service.
Before You Begin
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on these hardware and software versions.
Cisco Intelligent Automation for Cloud 4.0 (any edition) and Service Deisgner
• 
Adding New Buttons to My VDC
In this section, you are presented with the steps to add a new action button to the My VDCs popover. Creating
a new service or modifying an existing service is beyond the scope of this document.
IAC and Service Designer
The procedure for creating new buttons in My VDCs requires the use of Service Designer.
Adding a New Button
The following example illustrates the steps for adding a new button to "Release Floating IP Address."
Step 1: Go to Service Designer as shown below in Diagram 1.