Cisco Cisco SG300-28 28-Port Gigabit Managed Switch Technical References

Introduction

78-21485-01 Command Line Interface Reference Guide

Layer 3 Switch with Static Routing

The following example shows you how to configure IP on a Layer 3 switch with
static routing:

The neighbor router 10.10.11.1 should be configured with the following static
route: ip route 172.25.13.2 /32 10.10.10.2.

The neighbor router 10.11.11.1 should be configured with the following static
route: ip route 172.25.13.2 /32 10.11.11.2.

The neighbor router 2001:DB8:2222:7270::1 connected to VLAN 1 should be
configured with the following static route:

ipv6 route 2001:DB8:2222:7272::72/128 2001:DB8:2222:7270::2312

Switch# configure terminal

Switch(config)# interface vlan 1

Switch(config-if)# ip address 10.10.10.2 /24

Switch(config-if)# ipv6 address 2001:DB8:2222:7270::2312/64

Switch(config-if)# exit

Switch(config)# interface vlan 2

Switch(config-if)# ip address 10.11.11.2 /24

Switch(config-if)# ipv6 address 2001:DB8:3333:7271::2312/64

Switch(config-if)# exit

Switch(config)# interface loopback 1

Switch(config-if)# ip address 172.25.13.2 /32

Switch(config-if)# ipv6 address 2001:DB8:2222:7272::72/128

Switch(config-if)# exit

Switch(config)# ip route 0.0.0.0/0 10.10.11.1

Switch(config)# ip route 10.11.0.0 /16 10.11.11.1

Switch(config)# ipv6 route 0::/0 2001:DB8:2222:7270::1

Switch(config)# ipv6 route 2001:DB8:3333::/48

2001:DB8:3333:7271::1