Cisco Cisco SG300-28 28-Port Gigabit Managed Switch Technical References

Address Table Commands

78-21485-01 Command Line Interface Reference Guide

477

29

Vlan  Group Address  Source address    Ports

---- --------------- ---------------   ----------

8    ff02::4:4:4     *                  gi9

8    ff02::4:4:4     fe80::200:7ff:f    gi9

                     e00:200

Use the show bridge multicast address-table static EXEC mode command to 
display the statically configured Multicast addresses.

Syntax

show bridge multicast address-table static 

[vlan vlan-id] [address 

mac-multicast-address | ipv4-multicast-address | ipv6-multicast-address] [source 
ipv4-source-address | ipv6-source-address] [all | mac | ip

]

Parameters

•

vlan vlan-id—Specifies the VLAN ID.

•

address—Specifies the Multicast address. The possible values are:

-

mac-multicast-address—Specifies the MAC Multicast address.

-

ipv4-multicast-address—Specifies the IPv4 Multicast address.

-

ipv6-multicast-address—Specifies the IPv6 Multicast address.

•

source—Specifies the source address. The possible values are:

-

ipv4-address—Specifies the source IPv4 address.

-

ipv6-address—Specifies the source IPv6 address.

Default Configuration 

When all/mac/ip is not specified, all entries (MAC and IP) will be displayed.

Command Mode

EXEC mode