Cisco Cisco SG300-28 28-Port Gigabit Managed Switch Technical References
Link Layer Discovery Protocol (LLDP) Commands
78-21485-01 Command Line Interface Reference Guide
641
37
Parameters
N/A
Default Configuration
Enabled
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
LLDP manages LAG ports individually. LLDP sends separate advertisements on
each port in a LAG.
each port in a LAG.
LLDP operation on a port is not dependent on the STP state of a port. I.e. LLDP
frames are sent on blocked ports.
frames are sent on blocked ports.
If a port is controlled by 802.1x, LLDP operates only if the port is authorized.
Example
switchxxxxxx(config)# interface gi1
switchxxxxxx(config-if)# lldp transmit
37.3
lldp receive
Use the lldp receive Interface Configuration mode command to enable receiving
LLDP on an interface. Use the no form of this command to stop receiving LLDP on
an interface.
LLDP on an interface. Use the no form of this command to stop receiving LLDP on
an interface.
Syntax
lldp receive
no lldp receive
Parameters
N/A
Default Configuration
Enabled