Cisco Cisco Email Security Appliance C190 Technical References

This section contains the following CLI commands:

Use the 

outbreakconfig

 command to configure the Outbreak Filter feature. You perform the following 

actions using this command:

Enable Outbreak Filters globally

Enable Adaptive Rules scanning

Set a maximum size for files to scan (note that you are entering the size in bytes)

Enable alerts for the Outbreak Filter

Enable Logging of URLs

Commit: This command requires a ‘commit’.

Cluster Management: This command can be used in all three machine modes (cluster, group, machine).

Batch Command: This command does not support a batch format.

mail.example.com> outbreakconfig

Outbreak Filters: Enabled

Choose the operation you want to perform:

- SETUP - Change Outbreak Filters settings.

[]> setup

Outbreak Filters: Enabled

Would you like to use Outbreak Filters? [Y]>

Outbreak Filters enabled.

Outbreak Filter alerts are sent when outbreak rules cross the threshold (go above or back 

down below), meaning that new messages of

certain types could be quarantined or will no longer be quarantined, respectively.

Would you like to receive Outbreak Filter alerts? [N]>

What is the largest size message Outbreak Filters should scan?