Cisco Cisco Email Security Appliance C190 Technical References

Log files successfully rolled over.

mail3.example.com>

Configure SNMP.

Commit: This command requires a ‘commit’.

Cluster Management: This command can be used in all three machine modes (cluster, group, machine).

Batch Command: This command does not support a batch format.

In the following example, the 

snmpconfig

 command is used to enable SNMP on the “PublicNet” 

interface on port 161. A passphrase for version 3 is entered and then re-entered for confirmation. The 
system is configured to service version 1 and 2 requests, and the community string 

public

 is entered for 

GET requests from those versions 1 and 2. The trap target of 

snmp-monitor.example.com

 is entered.  

Finally, system location and contact information is entered.

mail3.example.com> snmpconfig

Current SNMP settings:

SNMP Disabled.

Choose the operation you want to perform:

- SETUP - Configure SNMP.

[]> setup

Do you want to enable SNMP? [N]> y

Please choose an IP interface for SNMP requests.

1. Data 1 (192.168.1.1/24: buttercup.run)

2. Data 2 (192.168.2.1/24: buttercup.run)

3. Management (192.168.44.44/24: buttercup.run)

[1]>

Enter the SNMPv3 passphrase.

>

Please enter the SNMPv3 passphrase again to confirm.

>

Which port shall the SNMP daemon listen on?

[161]>

Service SNMP V1/V2c requests? [N]> y

Enter the SNMP V1/V2c community string.

[]> public

From which network shall SNMP V1/V2c requests be allowed?

[192.168.2.0/24]>