Cisco Cisco IPCC Web Option Installation Guide

How to Configure the IPCC Enterprise Gateway PIM

To configure the PIM, complete the following steps:

1. In the IPCC Enterprise Gateway Configuration dialog box, to put the PIM into service,

check the Enabled option. This allows the PIM to communicate with the peripheral when
the Peripheral Gateway is running.

2. In the Peripheral name field, enter the Peripheral name of the parent server from the

Configuration Manager (use the PG Explorer tool to view the Peripheral name).

3. In the Peripheral ID field, from the Peripheral record, enter the Peripheral ID value of

the parent server from the Configuration Manager (use the PG Explorer tool to view the
Peripheral ID).

4. In System A name, enter the hostname or IP address of the Side A child server.

5. In System A port, enter the port on the Side A child server (the server port of the CG).

6. In System A Peripheral ID, enter the peripheral ID of the Side A child peripheral.

Note: Currently, in a System IPCC system (where there is web-based configuration), only
one peripheral is supported on a System IPCC child system; its Peripheral ID value is
1000. However, this is only the case where "System IPCC" (web based configuration) is
used. In other cases, the true PeripheralID of the Child System IPCC should be used to
propagate the skill groups.

7. If the child system is duplexed, in System B name, System B port, and System B

Peripheral ID, enter the corresponding information for Side B. If the child system is
simplexed, leave these fields blank.

Figure 8: Example IPCC Gateway Configuration

Cisco IPCC Gateway Deployment Guide for Unified ICME, Unified CCE, and Unified CCX, Enterprise Releases 7.2(1) and Express Release 5.0(1)