Cisco Cisco TelePresence MCU 4510 Installation Guide
Ensure Incoming calls to unknown conferences or auto attendants is set to Disconnect caller.
3. Ensure Time to wait when setting up ad hoc conference PINis set to <never configure PIN> .
4. Click Apply changes.
5. Go to
Gatekeeper > Built in Gatekeeper
.
6. Under
Configuration
ensure Status is set to Disabled.
Note: The MCU 5300 series does not have a built-in Gatekeeper.
7. Click Apply changes.
Configuring the Unified CM for Ad hoc conferencing
This deployment assumes you are using a non-secure deployment. If you are using a secure deployment you
will need to generate a certificate and private key. Refer to
will need to generate a certificate and private key. Refer to
for more
information.
Task 1: Add the MCU as a Conference bridge to Unified CM for Ad hoc
conferences
conferences
1. Go to
Media Resources > Conference Bridge
.
2. Click Add New to create a new conference bridge.
3. Enter the following into the relevant fields, leave other fields as their default values:
Conference
Bridge Type
Bridge Type
Select Cisco TelePresence MCU.
Conference
Bridge Name
Bridge Name
Enter the MCU's name.
Destination
Address
Address
Enter the MCU's IP address.
Cisco TelePresence MCU Deployment Guide 4.4
Page 40 of 53
Deploying an MCU as a Unified CM media resource