Cisco Cisco Firepower Management Center 4000
35-49
FireSIGHT System User Guide
Chapter 35 Introduction to Network Discovery
Obtaining User Data from LDAP Servers
To configure the agent:
Access:
Any
Step 1
On the computer where you installed the agent, select
Start > Programs >
Sourcefire
> Configure User Agent
.
The Active Directory User Agent dialog box appears, with the General tab active.
The following table describes the actions you can take when configuring the agent and where to
configure them. For more information, see the FireSIGHT System User Agent Configuration Guide.
configure them. For more information, see the FireSIGHT System User Agent Configuration Guide.
Table 35-6
User Agent Configuration Actions
To...
You can...
change the agent name, change the logoff check frequency, and start and
stop the service
stop the service
select the
General
tab.
add, modify, or remove Active Directory servers, enable real-time Active
Directory server data retrieval, and modify the Active Directory server
polling interval and maximum poll length
Directory server data retrieval, and modify the Active Directory server
polling interval and maximum poll length
select the
Active Directory Servers
tab.
add or remove Defense Centers
select the
Cisco
DCs
tab.
add, modify, or remove user names excluded from reporting
select the
Excluded Usernames
tab.
add, modify, or remove IP addresses excluded from reporting
select the
Excluded Addresses
tab.
view, export, and clear the event log, log to Windows application logs,
and modify how long messages should be kept
and modify how long messages should be kept
select the
Logs
tab.
perform troubleshooting and maintenance tasks, as directed by Support
select the
Logs
tab, enable
Show Debug Messages in
Log
, then select the
Maintenance
tab.
save changes to the agent settings
click
Save
. A message displays below
Save
stating
when you have unsaved changes.
close the agent without saving changes to the agent settings
click
Cancel
.