Cisco Cisco Firepower Management Center 4000

FireSIGHT

To create a custom topology, you must specify its networks. You can do this using any or all of three 
strategies:

by importing the Cisco-discovered topology, which adds networks using a “best guess” at how your 
network is deployed based on the hosts and network devices the system has detected

by importing networks from a network discovery policy, which adds the networks that you 
configured the FireSIGHT System to monitor in a network discovery policy

by adding networks to your topology manually, if the other two methods create an inaccurate or 
incomplete representation of your deployment

You must save and activate the topology before using it with the network map.

Admin/Discovery Admin

Select 

, then click 

.

The Custom Topology page appears.

Click 

.

The Create Topology page appears.

Provide basic topology information, such as the topology name and description.

See 

Add networks to your topology. You can use any or all of the following strategies:

To add networks to your topology by importing the Cisco-discovered topology, follow the procedure 
in 

To add networks to your topology by importing them from a network discovery policy, follow the 
procedure in see 

.

To add networks to your topology manually, follow the procedure in 

Refine your topology:

To remove a network from your custom topology, click 

 next to the network you want to 

remove.

To rename a network, click 

 next to the network. In the pop-up window that appears, type the 

new name in the 

 field and click 

. This name labels the network in the network map.

Click 

.

The topology is saved.