Cisco Cisco Firepower Management Center 4000

Select 

.

The Detectors page appears.

Locate the detector you want to activate or deactivate.

If the detector you want to activate or deactivate is not on the first page, you can find it by paging through 
the detector list or applying one or more filters. For more information, see 

You have the following options:

To activate a detector, so that the system will use it when analyzing network traffic, click the 
deactivated slider (

) next to the detector.

To deactivate a detector so that the system will not use it when analyzing network traffic, click the 
activated slider (

) next to the detector.

Note that some application detectors are required by other detectors. If you deactivate one of these 
detectors, a warning appears to indicate that the detectors that depend on it are also disabled.

FireSIGHT

Use the following procedure to modify user-defined application detectors. 

Admin/Discovery Admin

Select 

.

The Detectors page appears.

Locate the detector you want to modify.

If the detector you want to modify is not on the first page, you can find it by paging through the detector 
list or applying one or more filters. For more information, see 

To modify a user-defined detector, click 

 next to the detector you want to modify.

The Edit Application Detector page appears.

Make changes to the detector.

See 

 for information on the various 

configurations you can change.

You have the following options:

If you are modifying an inactive user-defined detector, either click 

 to save your changes, or 

click 

 to save the detector as a new, inactive user-defined detector.

If you are modifying an active user-defined detector, either click 

 to save your 

changes and immediately start using the modified detector, or click 

 to save the detector 

as a new, inactive user-defined detector.