Cisco Cisco Firepower Management Center 4000

operating systems, applications, or servers up to date. If the host is deleted from the network map and 
re-added, any Nmap scan results are discarded and the system resumes monitoring of all operating 
system and service data for the host.

Admin/Maint

Select 

. 

The Scheduling page appears.

Click 

.

The New Task page appears.

From the 

 list, select 

.

The page reloads to show the options for automating Nmap scans.

Specify how you want to schedule the task, 

 or 

:

For one-time tasks, use the drop-down lists to specify the start date and time. The 

 field 

indicates the current time on the appliance.

For recurring tasks, you have several options for setting the interval between instances of the task. 
See 

 for details.

In the 

 field, type a name using up to 255 alphanumeric characters, spaces, or dashes.

In the 

field, select the Nmap remediation to use when running the scan.

In the 

field, select the scan target that defines the target hosts you want to scan.

Optionally, in the 

 field, type a comment using up to 255 alphanumeric characters, spaces, or 

periods.

The comment field appears in the View Tasks section of the page, so you should try to keep it relatively 
short.

Optionally, in the 

 field, type the email address (or multiple email addresses separated by 

commas) where you want status messages sent.

You must have a valid email relay server configured to send status messages. See 

 for more information about configuring a relay host.

Click 

.

The task is added. You can check the status of a running task on the Task Status page; see 

.

Protection

You can queue an intrusion policy apply to a managed device. This task only applies the intrusion policy 
if an access control policy that references the intrusion policy is applied to the selected device when the 
task runs. Otherwise, the task aborts before completion.