Cisco Cisco Firepower Management Center 4000

The Health Policy Configuration — Intrusion Event Rate page appears.

Select 

 for the 

 option to enable use of the module for health status testing.

In the 

 field, enter the number of events per second that should trigger a critical 

health status.

In the 

 field, enter the number of events per second that should trigger a 

warning health status.

You have three options:

To save your changes to this module and return to the Health Policy page, click 

.

To return to the Health Policy page without saving any of your settings for this module, click 

.

To temporarily save your changes to this module and switch to another module’s settings to modify, 
select the other module from the list at the left of the page. If you click 

 when you 

are done, all changes you made will be saved; if you click 

, you discard all changes.

You must apply the health policy to the appropriate devices if you want your settings to take effect. See 

 for more information.

Any

Use the License Monitoring health status module to determine if sufficient licenses remain for Control, 
Protection, URL Filtering, Malware, and VPN. This module alerts if the number of remaining licenses 
is low or insufficient.

This module also alerts if the system detects that devices in a stacked configuration have mismatched 
license sets (stacked devices must have identical sets of licenses).

The License Monitoring module is automatically configured. Because you cannot change or disable this 
module, it does not appear on the Health Policy Configuration page.

Any

Use the Link State Propagation health status module to detect the link state propagation status on an 
inline pair. If a link state propagates to the pair, the status classification for that module changes to 
Critical and the state reads:

Module Link State Propagation: ethx_ethy is Triggered

where 

x

 and 

y

 are the paired interface numbers.

Admin/Maint

On the Health Policy Configuration page, select 

.

The Health Policy Configuration — Link State Propagation monitor page appears.

Select 

 for the 

 option to enable use of the module for health status testing.

You have three options: