Cisco Cisco Firepower Management Center 4000

Protection

You can add inline sets from the Inline Sets tab of the Device Management page. You can also add inline 
sets as you configure inline interfaces.

You can assign only inline interface pairs to an inline set. If you want to create an inline set before you 
configure the inline interfaces on your managed devices, you can create an empty inline set and add 
interfaces to it later.

You can also add multiple interface pairs when your network uses asynchronous routing, as shown in the 
following diagram.

Name

The name of the inline set.

Interface Pairs

A list of all pairs of inline interfaces assigned to the inline set. A pair is not 
available when you disable either interface in the pair from the Interfaces tab.

Bypass

The configured bypass mode of the inline set.