Cisco Cisco Firepower Management Center 4000
7-11
FireSIGHT System User Guide
Chapter 7 Setting Up an IPS Device
Configuring Sourcefire Software for X-Series Interfaces
You cannot reconfigure Sourcefire Software for X-Series interfaces using the FireSIGHT System web
interface. To reconfigure, you must first delete the current interface from the Defense Center, then create
a new interface. For more information on creating and deleting interfaces, see the Sourcefire Software
for X-Series Installation Guide.
interface. To reconfigure, you must first delete the current interface from the Defense Center, then create
a new interface. For more information on creating and deleting interfaces, see the Sourcefire Software
for X-Series Installation Guide.
To configure an interface on Sourcefire Software for X-Series:
Access:
Admin/Network Admin
Step 1
Select
Devices > Device Management
.
The Device Management page appears.
Step 2
Next to the device you want to configure, click the edit icon (
).
The Interfaces tab appears. Note that Link is always shown as active (
) for all Sourcefire Software
for X-Series interfaces.
Step 3
Next to the interface you want to configure, click the edit icon (
).
Step 4
From the
Security Zone
drop-down list, select an existing security zone or select
New
to add a new security
zone.
Step 5
Optionally, for an inline interface, from the
Inline Set
drop-down list, select an existing inline set or select
New
to add a new inline set.
Note that if you add a new inline set, you must configure it on the Device Management page (
Devices >
Device Management > Inline Sets
) after you set up the inline interface. For more information, see
Step 6
Click
Save
.
The interface is configured. Note that your changes do not take effect until you apply the device
configurations by clicking
configurations by clicking
Apply Changes
at top right of the menu bar.