Cisco Cisco Firepower Management Center 4000

Page of 1844
 
9-10
FireSIGHT System User Guide
 
Chapter 9      Setting Up Virtual Routers 
  Configuring Virtual Routers
  •
  •
To add a virtual router:
Access: 
Admin/Network Admin
Step 1
Select 
Devices > Device Management
.
The Device Management page appears.
Step 2
Next to the device where you want to add the virtual router, click the edit icon (
).
The Interfaces tab for that device appears.
Step 3
Click 
Virtual Routers
.
The Virtual Routers tab appears.
Tip
If your devices are in a clustered stack deployment, select the stack you want to modify from the 
Selected 
Device
 drop-down list.
Step 4
Click 
Add Virtual Router
.
The Add Virtual Router pop-up window appears.
Step 5
In the 
Name
 field, type a name for the virtual router. You can use alphanumeric characters and spaces.
Step 6
To enable IPv6 static routing, OSPFv3, and RIPng on your virtual router, select the
 IPv6 Support
 check 
box. To disable these features, deselect the check box.
Step 7
Optionally, clear 
Strict TCP Enforcement
 if you do not want to enable strict TCP enforcement. 
This option is enabled by default.
Step 8
Under 
Interfaces
, the 
Available
 list contains all enabled Layer 3 interfaces, routed and hybrid, on the 
device that you can assign to the virtual router. Select one or more interfaces to assign to the virtual 
router and click 
Add
.
Tip
To remove a routed or hybrid interface from the virtual router, click the delete icon (
). Disabling a 
configured interface from the Interfaces tab also removes it.
Step 9
Click 
Save
.
The virtual router is added. Note that your changes do not take effect until you apply the device 
configuration; see 
.
Setting Up DHCP Relay
License: 
Control
Supported Devices: 
Series 3