Cisco Cisco Firepower Management Center 4000
9-15
FireSIGHT System User Guide
Chapter 9 Setting Up Virtual Routers
Configuring Virtual Routers
See the following sections for more information:
•
•
Setting Up RIP Configuration
License:
Control
Supported Devices:
Series 3
Routing Information Protocol (RIP) is a dynamic routing protocol, designed for small IP networks, that
relies on hop count to determine routes. The best routes use the fewest number of hops. The maximum
number of hops allowed for RIP is 15. This hop limit also limits the size of the network that RIP can
support.
relies on hop count to determine routes. The best routes use the fewest number of hops. The maximum
number of hops allowed for RIP is 15. This hop limit also limits the size of the network that RIP can
support.
See the following sections for more information on configuring RIP:
•
•
•
•
•
Adding Interfaces for RIP Configuration
License:
Control
Supported Devices:
Series 3
While configuring RIP, you must select interfaces from those already included in the virtual router,
where you want to configure RIP. Disabled interfaces are not available.
where you want to configure RIP. Disabled interfaces are not available.
To edit a RIP interface, click the edit icon (
). To delete a RIP interface, click the delete icon (
).
To add an interface for RIP configuration:
Access:
Admin/Network Admin
Step 1
Select
Devices > Device Management
.
The Device Management page appears.
Step 2
Next to the device where you want to add the RIP interface, click the edit icon (
).
The Interfaces tab for that device appears.
Step 3
Click
Virtual Routers
.
The Virtual Routers tab appears.
Step 4
Next to the virtual router where you want to add the RIP interface, click the edit icon (
).
The Edit Virtual Router pop-up window appears.
Step 5
Click
Dynamic Routing
to display the dynamic routing options.
Step 6
Click
RIP
to display the RIP options.
Step 7
Under
Interfaces
, click the add icon (
).