Cisco Cisco Firepower Management Center 4000

The Add an Interface pop-up window appears.

From the 

 drop-down list, select the interface where you want to configure RIP. 

Interfaces you have disabled from the Interfaces tab are not available; disabling an interface you have 
added removes it from the configuration.

In the 

 field, type a metric for the interface. When routes from different RIP instances are available 

and all of them have the same preference, the route with the lowest metric becomes the preferred route.

From the 

 drop-down list, select one of the following options:

 — default mode where RIP multicasts the entire routing table to all adjacent routers at a 

specified address.

 — forces RIP to use broadcast (for example, RIPv1) even though multicast mode is 

possible.

 — RIP will not transmit any periodic messages to this interface.

 — RIP will send to this interface but not listen to it.

Click 

.

Your changes are saved. Note that your changes do not take effect until you apply the device 
configuration; see 

.

Control

Series 3

RIP authentication uses one of the authentication profiles you configured on the virtual router. For more 
information about configuring authentication profiles, see 

.

Admin/Network Admin

Select 

.

The Device Management page appears.

Next to the device where you want to add the RIP authentication profile, click the edit icon (

).

The Interfaces tab for that device appears.

Click 

.

The Virtual Routers tab appears.

Next to the virtual router where you want to add the RIP authentication profile, click the edit icon (

).

The Edit Virtual Router pop-up window appears.

Click 

to display the dynamic routing options.

Click 

 to display the RIP options.