Cisco Cisco Firepower Management Center 4000
9-18
FireSIGHT System User Guide
Chapter 9 Setting Up Virtual Routers
Configuring Virtual Routers
•
Always
— always honor requests
•
Neighbor
— only honor requests sent from a host on a directly connected network
•
Never
— never honor requests
Step 13
Click
Save
.
Your changes are saved. Note that your changes do not take effect until you apply the device
configuration; see
configuration; see
.
Adding Import Filters for RIP Configuration
License:
Control
Supported Devices:
Series 3
You can add an import filter to designate which routes are accepted or rejected from RIP into the route
table. Import filters are applied in the order they appear in the table.
table. Import filters are applied in the order they appear in the table.
When adding an import filter, you use one of the filters you configured on the virtual router. For more
information about configuring filters, see
information about configuring filters, see
Tip
To edit a RIP import filter, click the edit icon (
). To delete a RIP import filter, click the delete icon
(
).
To add an import filter for RIP configuration:
Access:
Admin/Network Admin
Step 1
Select
Devices > Device Management
.
The Device Management page appears.
Step 2
Next to the device where you want to add the RIP virtual router filter, click the edit icon (
).
The Interfaces tab for that device appears.
Step 3
Click
Virtual Routers
.
The Virtual Routers tab appears.
Step 4
Next to the virtual router where you want to add the RIP virtual router filter, click the edit icon (
).
The Edit Virtual Router pop-up window appears.
Step 5
Click
Dynamic Routing
to display the dynamic routing options.
Step 6
Click
RIP
to display the RIP options.
Step 7
Under
Import Filters
, click the add icon (
).
The Add an Import Filter pop-up window appears.
Step 8
From the
Name
drop-down list, select the filter you want to add as an import filter.
Step 9
Next to
Action
, select
Accept
or
Reject
.
Step 10
Click
OK
.
The import filter is added.