Cisco Cisco Firepower Management Center 4000
9-29
FireSIGHT System User Guide
Chapter 9 Setting Up Virtual Routers
Configuring Virtual Routers
Step 1
Select
Devices > Device Management
.
The Device Management page appears.
Step 2
Next to the device where you want to add the virtual filter router, click the edit icon (
).
The Interfaces tab for that device appears.
Step 3
Click
Virtual Routers
.
The Virtual Routers tab appears.
Step 4
Next to the virtual router where you want to add the virtual filter router, click the edit icon (
).
The Edit Virtual Router pop-up window appears.
Step 5
Click
Filter
to display the Filter options.
Step 6
Click
Add Filter
.
The Create Filter pop-up window appears.
Step 7
In the
Name
field, type a name for the filter. You can use alphanumeric characters only.
Step 8
Under
Protocol
, select
All
or select the protocol that applies to the filter.
Step 9
If you selected All, Static, or RIP as the Protocol, under
From Router
, type the router IP addresses that this
filter will attempt to match in a route.
Note that you can also enter a /32 CIDR block for IPv4 addresses and a /128 prefix length for IPv6
addresses. All other address blocks are invalid for this field.
addresses. All other address blocks are invalid for this field.
Step 10
Click
Add
.
The
From Router
field is populated.
Step 11
If you selected All, Static, or RIP as the Protocol, under
Next Hop
, type the IP addresses for the gateways
that this filter will attempt to match in a route.
Note that you can also enter a /32 CIDR block for IPv4 addresses and a /128 prefix length for IPv6
addresses. All other address blocks are invalid for this field.
addresses. All other address blocks are invalid for this field.
Step 12
Click
Add
.
The
Next Hop
field is populated.
Step 13
Under
Destination Type
, select the options that apply to the filter.
Step 14
Under
Destination Network
, type the IP address of the network that this filter will attempt to match in a
route.
Step 15
Click
Add
.
The
Destination Network
field is populated.
Step 16
If you selected All or OSPF as the Protocol, under
Path Type
, select the options that apply to the filter.
You must select at least one path type.
Step 17
If you selected OSPF as the Protocol, under
Router ID
, type the IP address that serves as the router ID of
the router advertising the route/network.
Step 18
Click
Add
.
The
Router ID
field is populated.
Step 19
Click
OK
.
The filter is added.
Step 20
Click
Save
.