Cisco Cisco Firepower Management Center 4000

The HTTP Configuration page appears. A message at the bottom of the page identifies the intrusion 
policy layer that contains the configuration. See 

 for more 

information.

You have two options:

Add a new server profile. Click the add icon (

) next to 

 on the left side of the page. The 

Add Target pop-up window appears. Specify one or more IP addresses for the client in the 

field and click 

. 

You can specify a single IP address or address block, or a comma-separated list of either or both. 
You can include up to 496 characters in a list, specify a total of 256 address entries for all server 
profiles, and create a total of 255 profiles including the default profile. For information on using 
IPv4 and IPv6 address blocks in the FireSIGHT System, see 

.

A new entry appears in the list of servers on the left side of the page, highlighted to indicate that it 
is selected, and the Configuration section updates to reflect the current configuration for the profile 
you added.

Modify the settings for an existing profile. Click the configured address for a profile you have added 
under 

 on the left side of the page, or click 

.

Your selection is highlighted and the Configuration section updates to display the current 
configuration for the profile you selected. To delete an existing profile, click the delete icon (

) 

next to the profile you want to remove.

Optionally, modify the address or addresses listed in the 

 field and click any other area of the 

page.

The highlighted address updates on the left side of the page.

Note that you cannot modify the setting for 

 in the default profile. The default profile applies to 

all servers on your network that are not identified in another profile.

In the 

 field, list the ports whose traffic you want to inspect with HTTP Inspect. Separate multiple 

ports with commas.

You can modify any of the other options described in 

Select a server profile as follows:

Select 

 to create your own server profile (see 

 for more information).

Select 

 to use the standard default profile, appropriate for all servers.

Select 

 to use the default IIS profile.

Select 

 to use the default Apache profile.

If you selected 

, the custom options appear.

Configure the HTTP decoding options you want in your profile.

See 

 for details on available 

normalization options.

Optionally, click 

 at the top of the page to display rules associated 

with individual options.

Click 

 to return to the HTTP Configuration page.