Cisco Cisco Web Security Appliance S670 Installation Guide
14
Command-Line Interface
Step 1
Access the command-line interface locally or remotely:
•
To access the CLI locally, set up a terminal to
connect to the serial port using 9600 bits, 8 bits, no
parity, 1 stop bit (9600, 8, N, 1) and flow control
set to Hardware. To physically connect the
terminal, see the
connect to the serial port using 9600 bits, 8 bits, no
parity, 1 stop bit (9600, 8, N, 1) and flow control
set to Hardware. To physically connect the
terminal, see the
).
•
To access the CLI remotely, initiate an SSH session
to the IP address 192.168.42.42.
to the IP address 192.168.42.42.
Step 2
Log in as admin with the password ironport.
Step 3
At the prompt, run the systemsetup command.
11
Run the System Setup Wizard
The System Setup Wizard starts automatically when you access
the appliance via the web-based interface and displays the end
user license agreement (also known as the EULA).
the appliance via the web-based interface and displays the end
user license agreement (also known as the EULA).
Step 1
Accept the end user license agreement.
Step 2
Enter information from the
“Document Network
Settings” section on page 4
.
If you need additional information about the settings,
choose Help and Support > Online Help.
choose Help and Support > Online Help.
Step 3
Review the configuration summary page.
Step 4
Click Install this Configuration.
Step 5
The appliance may not appear to have accepted your
configuration or be performing the installation. This is
because you have changed the IP address, but the
installation is underway.
configuration or be performing the installation. This is
because you have changed the IP address, but the
installation is underway.
Step 6
If you temporarily changed the IP address of your
computer as described above, change the IP address
settings back to the original values.
computer as described above, change the IP address
settings back to the original values.