Cisco Cisco SG300-28 28-Port Gigabit Managed Switch Technical References
DHCP Snooping Commands
OL-32830-01 Command Line Interface Reference Guide
326
13
User Guidelines
Since the IP Source Guard uses the Ternary Content Addressable Memory
(TCAM) resources, there may be situations when IP Source Guard addresses are
inactive because of a lack of TCAM resources.
(TCAM) resources, there may be situations when IP Source Guard addresses are
inactive because of a lack of TCAM resources.
By default, once every minute the software conducts a search for available space
in the TCAM for the inactive IP Source Guard addresses.
in the TCAM for the inactive IP Source Guard addresses.
Use the
command to change the retry
frequency or to disable automatic retries for TCAM space.
Use the
command to manually retry locating TCAM
resources for the inactive IP Source Guard addresses.
This command displays the inactive IP source guard addresses.
Example
The following example displays the IP source guard inactive addresses.
13.19 show ip source-guard statistics
Use the show ip source-guard statistics EXEC mode command to display the
Source Guard dynamic information (permitted stations).
Source Guard dynamic information (permitted stations).
Syntax
show ip source-guard statistics [
vlan
vlan-id
]
Parameters
•
vlan-id
—Display the statistics on this VLAN.
switchxxxxxx#
show ip source-guard inactive
TCAM resources search frequency: 60 seconds
Interface
--------
gi12
gi13
gi14
Filter
-----
IP
IP
I
IP
Address
---------
10.1.8.32
MAC Address
-----------
0060.704C.8
3FF
VLAN
-----
3
Type
----
DHCP
Reason
----------
Resource
Problem
Trust port