Cisco Cisco SG300-28 28-Port Gigabit Managed Switch Technical References

IP Routing Protocol-Independent Commands

OL-32830-01 Command Line Interface Reference Guide

470

23

•

address 

ip-address

—IP address about which routing information should be 

displayed. 

•

mask

—The value of the subnet mask. 

•

longer-prefixes—Specifies that only routes matching the IP address and 
mask pair should be displayed.

•

connected—Displays connected routes. 

•

icmp—Displays routes added by ICMP Direct. 

•

rejected—Displays rejected routes. 

•

static—Displays static routes. 

User EXEC mode

Privileged EXEC mode

Use this command without parameters to display the whole IPv6 Routing table. 

Use this command with parameters to specify required routes.

Example 1. The following is sample output from the show ip route command when 
IP Routing is not enabled: 

switchxxxxxx# 

show ip route

Maximum Parallel Paths: 1 (1 after reset)

IP Forwarding: disabled

Codes: > - best, C - connected, S - static, I - ICMP

IP Routing Table - 5 entries

Code     IP Route      Distance/  Next Hop           Last Time Outgoing

                                  Metric       IP Address        Updated   Interface

------  -------------------  -----------    ---------------       ------------- ------------

S>     10.10.0.0/16     1/128       10.119.254.244  00:02:22  vlan2