Cisco Cisco SG300-28 28-Port Gigabit Managed Switch Technical References
Management ACL Commands
OL-32830-01 Command Line Interface Reference Guide
700
33
•
mask
prefix-length
— Specifies the number of bits that comprise the source
IPv4 address prefix. The prefix length must be preceded by a forward slash
(/). This parameter is relevant only to IPv4 addresses. (Range: 0–32)
(/). This parameter is relevant only to IPv4 addresses. (Range: 0–32)
Default Configuration
No rules are configured.
Command Mode
Management Access-list Configuration mode
User Guidelines
Rules with Ethernet, VLAN, and port-channel parameters are valid only if an IP
address is defined on the appropriate interface.
address is defined on the appropriate interface.
Example
The following example permits all ports in the ACL called mlist
switchxxxxxx(config)#
management access-list mlist
switchxxxxxx(config-macl)#
switchpermit
33.3 management access-list
To configure a management access list (ACL) and enter the Management
Access-list Configuration mode, use the management access-list Global
Configuration mode command. To delete an ACL, use the no form of this command.
Access-list Configuration mode, use the management access-list Global
Configuration mode command. To delete an ACL, use the no form of this command.
Syntax
management access-list
name
no management access-list
name
Parameters
name—Specifies the ACL name. (Length: 1–32 characters)
Default Configuration
N/A