functionality included in Version 5.3.0.6 of the Sourcefire 3D System.
For detailed information, see the Sourcefire 3D System User Guide, Installation

Guide, Virtual Installation Guide, and Sourcefire Software for X-Series Installation

and Configuration Guide.

Updates to Sourcefire Documentation

The documentation provided for Version 5.3.0.6 includes the following errors:

•

The FireSIGHT System User Guide incorrectly states that

You can use

Lights-Out Management (LOM) on the default (eth0) management
interface on a Serial Over LAN (SOL) connection to remotely
monitor or manage Series 3 appliances without logging into the
management interface of the appliance

when you cannot.

If you attempt to use the same IP address in LOM and your Series 3 device,

the system does not allow you to log into the management interface of the

device. (CSCuu17674)

•

The FireSIGHT System User Guide does not reflect that you can now

choose whether to inspect traffic during policy apply. Inspecting traffic

during policy apply on a heavily loaded system may have an impact on

network throughput and latency. If this side effect is not ideal for your

network setup and connectivity is more important than inspection,

unchecking this box will disable inspection temporarily during policy apply

and ensure that no packets are dropped during the procedure. After policy

apply is successful inspection will resume as normal. (144574/CSCze95159,

144571/CSCze95210)