Cisco Cisco Administrative Workstation User Guide
C H A P T E R
2-1
Cisco ICM Enterprise Edition SS7 Gateway Configuration Tool User Guide Release 6.0(0)
2
Using SS7Cfg to Configure Your
Gateway
Gateway
Overview
For the purposes of this exercise, the following sample network configuration will
be used to set up an SS7 Generic (ITU) gateway using SS7Cfg.
be used to set up an SS7 Generic (ITU) gateway using SS7Cfg.
Note
The example exercise configures the network interface from the bottom up, which
is consistent with the way SS7Cfg was defined. (Notice that only Gateway 1 will
be configured in this example.)
is consistent with the way SS7Cfg was defined. (Notice that only Gateway 1 will
be configured in this example.)
In
, Gateway 1 has four links connecting to two different Signal
Transfer Points (STPs). Each STP is connected by two links combined into a
linkset. Gateway 1 has a point code of 150 and is connected to two STPs with
point codes of 10 and 11. Behind the STPs are two Service Switching Points
(SSPs) at point codes 200 and 201.
linkset. Gateway 1 has a point code of 150 and is connected to two STPs with
point codes of 10 and 11. Behind the STPs are two Service Switching Points
(SSPs) at point codes 200 and 201.