Cisco Cisco Web Security Appliance S690 User Guide

Connect the Appliance to networks and devices. See 

.

Complete the System Setup Wizard worksheet. See 

If you are setting up a virtual appliance: 

Use the 

loadlicense

 command to load the virtual appliance license. For complete information, 

see the Cisco Content Security Virtual Appliance Installation Guide, available from 

Enable the HTTP and/or HTTPS interfaces: In the command-line interface (CLI), run the 

interfaceconfig

 command. 

Note that reference information for each configuration item used in the System Setup Wizard is 
available at 

.

Open a browser and enter the IP address of the Web Security appliance. The first time you run the System 
Setup Wizard, use the default IP address:

https://192.168.42.42:8443

 

-or-

http://192.168.42.42:8080

 

where 

192.168.42.42 

is the default IP address, and

 8080 

is the default admin port setting for HTTP, 

and 

8443

 is default admin port for HTTPS.

Otherwise, if the appliance is currently configured, use the IP address of the M1 port.

When the appliance login screen appears, enter the user name and passphrase to access the appliance. 
By default, the appliance ships with the following user name and passphrase:

User name: 

Passphrase: 

You must immediately change the passphrase.

Choose System Administration > System Setup Wizard.

If the appliance is already configured, you will be warned that you are about to reset the configuration. 
To continue with the System Setup Wizard, click the Reset Configuration button. The appliance will 
reset and the browser will refresh to the appliance home screen.

Read and accept the terms of the end-user license agreement. 

Click Begin Setup to continue.

Configure all settings using the reference tables provided in the following sections as required. See 

.

Review the configuration information. If you need to change an option, click Edit for that section.