Cisco Cisco Content Security Management Appliance M390 User Guide
2-9
Cisco IronPort AsyncOS 8.0 for Security Management User Guide
Chapter 2 Setup, Installation, and Basic Configuration
•
System time settings
•
Admin password
Step 3
Configuring the following network settings:
•
Hostname of the appliance
•
IP address, network mask, and gateway of the appliance
•
Default router and DNS settings
Step 4
Reviewing your configuration
Proceed through the wizard pages, and carefully review your configuration at step 4. You can return to
a step by clicking Previous. At the end of the process, the wizard prompts you to commit the changes
that you have made. Most changes do not take effect until you commit them.
a step by clicking Previous. At the end of the process, the wizard prompts you to commit the changes
that you have made. Most changes do not take effect until you commit them.
Launch the System Setup Wizard
To launch the wizard, log in to the GUI as described in the
. The first time you log in to the GUI, the initial page of the System Setup Wizard appears by
default. You can also access the System Setup Wizard from the System Administration menu
(Management Appliance > System Administration > System Setup Wizard).
(Management Appliance > System Administration > System Setup Wizard).
Review the End User License Agreement
Begin by reading the license agreement. After you have read and agreed to the license agreement, select
the check box indicating that you agree, and then click Begin Setup to proceed.
the check box indicating that you agree, and then click Begin Setup to proceed.
Configure the System Settings
Figure 2-2
Configuring System Settings with the System Configuration Page
Entering an Email Address for System Alerts
AsyncOS sends alert messages through email if there is a system error that requires your intervention.
Enter the email address (or addresses) where the alerts are sent.
Enter the email address (or addresses) where the alerts are sent.