Cisco Cisco Prisma II EDR Receiver Data Sheet

Page of 8
 
 
© 2007-2011 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. 
Page 1 of 8 
Data Sheet 
Cisco Prisma II High Density Dual Reverse Optical 
Receivers 
The Cisco
®
 Prisma
®
 II optical network is an advanced transmission system designed to 
optimize network architectures and increase reliability, scalability, and cost-effectiveness. 
The Prisma II High Density Dual Reverse Optical Receiver (HD-RXR) modules are 
available in the half-height High Density form factor. 
The HD-RXR modules contain two independent reverse optical receivers and two RF output ports. 
A single HD-RXR module occupies one slot in a Prisma II XD chassis. Two such modules can be 
vertically stacked in an associated Prisma II Host Module that occupies a single-wide slot in the 
Prisma II standard chassis. Up to 26 HD-RXR modules can operate in a standard 6RU chassis,* 
while up to 16 HD-RXR modules can operate in the Prisma II XD chassis. 
The ability to mix high density receivers with other Prisma II modules in the same chassis greatly 
enhances the flexibility of the platform. HD-RXR modules are available in three versions: Standard 
Gain, High Gain, and Low Noise. 
* The 56-connector version of the chassis is required to make use of all 4 receivers in one chassis 
slot.
 
Figure 1. 
Cisco Prisma II High Density Dual Reverse Receiver (Left) and Populated Host Module (Right)