Cisco Cisco Prisma II EDR Receiver Installation Guide
3-14
Operation Using the ICIM
78-748704-01 Rev C
ICIM Operation
Introduction
Once the module is installed as described in Chapter 2, Installation, it runs without
the aid of an operator. Unless alarms are generated or your system configuration
changes, you should not need to adjust the module beyond the initial setup.
Accessing the ICIM LCD Contrast
To access the ICIM LCD contrast control from the MAIN menu, press the
ICIM
key.
Use the
key to increase or the
key to decrease ICIM display contrast.
The MAIN Menu
A few seconds after power-up, the MAIN menu (shown below) is displayed. Press
the
the
SEL
key to select the specific option.
M A I N
- - - - - - - - - -
O f f l i n e
- - - - - - - - - -
M o d u l e s
1 5
- - - - - - - - - -
A l a r m s
0
- - - - - - - - - -
S c r o l l
- - - - - - - - - -
M o d u l e
S h e l f
S l o t
The table below shows descriptions of the menu options.
ICIM Menu Option
Description
Offline
Indicates TNCS communication status with the ICIM
Modules
Indicates the number of modules in the ICIM domain
Alarms
Displays the number of modules that are in alarm. Selecting this
option allows scrolling through all modules in alarm condition.
Scroll
Allows scrolling through all modules in the ICIM domain
Module Shelf Slot
Allows selection of any specific module in the ICIM domain