Cisco Cisco Prisma II EDR Receiver Installation Guide
3-18
Operation Using the ICIM
78-748704-01 Rev C
Monitor Processor Status Using the ICIM
Introduction
The ICIM allows you to monitor the operating status of parameters.
STATUS Parameters
The table below describes the monitored status parameters for this processor.
Parameter
Units
Function
ExtPower
OK or Fault
Indicates DC power supply voltage status.
+1_8VInt
V
Internal voltage level-nominal 1.8 V DC.
+3_3VInt
V
Internal voltage level-nominal 3.3 V DC.
ProcTemp
°
C
Indicates processor temperature.
Rcv1Pres
Yes or No
Indicates if receiver 1 is installed.
Rcv1Type
1 or 2
Indicates what type receiver is installed.
1 = standard range receiver - PIN
2 = extended range receiver - APD
RF_Out1A
RF_Out1B
On or Off
Indicates whether the actual output of RF
channels A and B are On or Off.
Rcv2Pres
Yes or No
Indicates if receiver 2 is installed.
Rcv2Type
1 or 2
Indicates what type receiver is installed.
1 = standard range receiver - PIN
2 = extended range receiver - APD
RF_Out2A
RF_Out2B
On or Off
Indicates whether the actual output of RF
channels A and B are On or Off.
Recv1
Active or Idle Indicates if receiver 1 is active.
RednRcv1
Master,
Internal, or
External
Indicates if receiver 1 has been configured as
Master, Internal, or External.