Cisco Cisco Prisma II ICIM 2 Installation Guide
78-748704-01 Rev C
Introduction
1-13
Processor Configuration Options,
Continued
External Connections
To connect an optical receiver configured as External in the processor to an optical
receiver outside of the processor, you must make proper electrical connections. To
connect an optical receiver configured as External to an optical receiver in the same
chassis, you must make a connection from the ALARMS OUT connector to the
ALARMS IN connector located on the chassis.
To connect an optical receiver configured as External in the processor to an optical
To connect an optical receiver configured as External in the processor to an optical
receiver outside of the chassis, you must make a connection from the ALARMS
OUT connector on the Connector Interface Panel of the chassis containing the master
optical receiver to the ALARMS IN connector on the Connector Interface Panel of
the chassis containing the optical receiver configured as External.
Factory Default Restoration
After initialization, you can restore the processor’s factory default configuration at
any time. An ICIM is required to implement the restore function. The Restore
Factory Defaults command is an item in the processor’s MFG. DATA menu.
For details about the ICIM, the MFG. DATA menu, and the required user password,
For details about the ICIM, the MFG. DATA menu, and the required user password,
refer to Chapter 3, Operation Using the ICIM.