Cisco Prisma II 1310 nm HDTx Transmitters Installation Guide
78-748704-01 Rev C
Operation Using LCI
4-17
Configure the Processor
Introduction
Using LCI, you can configure several parameters.
Configurable Parameters
The table below lists the configurable parameters of the processor.
Parameter
Function
Values
Default
Receiver 1 Active State
Controls whether receiver 1
is active or idle.
Active or
Idle
Active
Receiver 1 Redundant
Mode
Configures receiver 1 as
Master (with or without
backup), Internal (backs-up
the other receiver in the same
processor), or External
(backs-up another receiver in
a separate processor). See
note on the following page.
Master,
External, or
Internal
Master
Receiver 1 RF Stream A
Output
Receiver 1 RF Stream B
Output
Receiver 2 RF Stream A
Receiver 2 RF Stream A
Output
Receiver 2 RF Stream B
Output
Controls the muting of RF
channels 1A, 1B, 2A, and 2B.
•
•
If Auto, the processor
determines if the output
is muted (based on alarms
such as missing receiver
or loss of signal).
•
If On, the output is not
muted.
•
If Off, the output is
muted.
Auto, On,
Off
Auto
Receiver 1 RF Stream A
Attenuator
Receiver 1 RF Stream B
Attenuator
Attenuates the RF output
channels 1A and 1B.
0 dB to
10 dB in
0.1 dB steps
0 dB