Cisco Cisco Email Security Appliance C190 Installation Guide

The appliance may not appear to have accepted your 
configuration or be performing the installation. This is 
because you have changed the IP address, but the 
installation is underway. 

If you temporarily changed the IP address of your 
computer as described in the 

change the IP address settings back to the original 
values. 

Ensure that your laptop and the appliance are 
connected to the network. 

Log back in to the appliance with the username admin 
and the new password that you set in the System Setup 
Wizard.

The Cisco C190 Email Security Appliance uses a 
self-signed certificate that may trigger a warning from 
your web browser. You can simply accept the certificate 
and ignore this warning.

Write down your new administrator password and 
keep it in a safe place.

After running the System Setup Wizard in the web interface, the 
Active Directory Wizard appears. If you are running an Active 
Directory server on your network, use the Active Directory 
Wizard to configure an LDAP server profile for the Active 
Directory server. 

If you are not using Active Directory or want to configure it 
later, click Skip this Step. You can run the Active Directory 
Wizard later by going to System Administration > LDAP. Select 
the “using Active Directory Wizard” check box, and then click 
Add LDAP Server Profile.