Cisco Cisco NAC Appliance 4.9.4 Installation Guide
34
Step 5
When configuration is done, reboot the machine with the command:
service perfigo reboot
Powering Down the NAC Appliance
To power down the CAM/CAS, use one of the following recommended methods while connected via
console/SSH. These methods prevent database corruption when powering down the CAM.
console/SSH. These methods prevent database corruption when powering down the CAM.
•
Type
service perfigo stop
, then power down the machine, or
•
Type
/sbin/halt
, then power down the machine.
4
Access the CAM Web Console
The Clean Access Manager web administration console is the primary interface for administering the
Cisco NAC Appliance deployment. After initial configuration is complete, use the following steps to
access the CAM web console.
Cisco NAC Appliance deployment. After initial configuration is complete, use the following steps to
access the CAM web console.
Step 1
Launch a web browser from a computer accessible to the CAM by network. (Microsoft
Internet Explorer 6.0 and 7.0 are supported.)
Internet Explorer 6.0 and 7.0 are supported.)
Step 2
In the URL/address field, type the IP address of the CAM (or the host name if you have made
the required entry in your DNS server).
the required entry in your DNS server).
Step 3
If using a temporary SSL certificate, the security alert appears and you are prompted to accept
the certificate. Click Yes to accept the certificate. (If using signed certificates, security dialogs
will not appear.)
the certificate. Click Yes to accept the certificate. (If using signed certificates, security dialogs
will not appear.)
Install CAM License
Step 4
The Clean Access Manager License Form displays (Figure 13). For convenience, the top of the
form displays the eth0 MAC address of the CAM appliance. Make sure you have already
obtained and saved your product license files to disk on the PC/laptop from which you are
accessing the CAM web console (as described in NAC Appliance Licensing, page 4).
form displays the eth0 MAC address of the CAM appliance. Make sure you have already
obtained and saved your product license files to disk on the PC/laptop from which you are
accessing the CAM web console (as described in NAC Appliance Licensing, page 4).