Cisco Cisco Email Security Appliance C680 Release Notes

(Email Security appliances only) Resume the operation of the appliance: 

Use the System Administration > Shutdown/Suspend page in the Web interface. 

-or-

Run the 

resume

 command in the CLI.

Configure settings not transferred by the configuration file. See 

. 

89817

CSCzv30028

WSA

These 

reportingconfig > counters

 settings are not preserved after upgrading 

or after using saveconfig, resetconfig, and loadconfig:

Minimally Limited Reporting Data.

Moderately Limited Reporting Data.

—

CSCuh03579

ESA

An error occurs when loading a configuration file that has an IPv6 in the 
Network Access settings.

91686

CSCzv58354

ESA

Configuration saved on an appliance was loaded back on either the same 
appliance or a new appliance and it produced an error due to an old packet 
capture test that used an interface that has been renamed since the packet 
capture.

Workaround: Set up the packet capture again and set the interface to "ALL."

If the interface is not set to "ALL" and you set it as a specific interface, it stores 
in to the configuration. When you try to load the configuration again after the 
interface name change it fails due to the file referencing an interface that is no 
longer available.

86130

CSCzv56986

ESA

An error occurs when you attempt to load a configuration file that contains an 
IPv6 address in a HAT sender group.

88881

CSCzv63858

ESA

The “message_tag_list” element may appear in the wrong order in the 
configuration guide when exporting from an appliance running AsyncOS for 
Email 7.6.1 and 7.6.2. This causes an error when loading the configuration file 
on another appliance.