Cisco Cisco Network Assistant Version 5.7 White Paper
8
Secure Network Foundation Implementation Guide for Single Site Deployments
Secure Network Foundation
Configuring IP Routing
Perform the following steps to configure IP routing.
Note
This information needs to be configured only if the service provider assigns static IP information
including IP addresses, default router, and so on.
including IP addresses, default router, and so on.
Step 1
From the Main menu, click Configure and choose Routing from the Task pane.
Step 2
In the Static Routing section, click Add.
Step 3
For the Destination Network, place a check mark in the Make this the default route check box.
Step 4
Under Forwarding (Next Hop), choose the IP Address option and enter the IP address of the default
router on the WAN. (The service provider will provide this IP address.)
router on the WAN. (The service provider will provide this IP address.)
Step 5
Place a check mark in the Permanent Route option check box to ensure that the route stays in the
routing table.
routing table.
Step 6
Click OK.
Step 7
After the configuration is delivered to the router, click OK.