Brother HL-1870N User Guide
CHAPTER 13 TROUBLESHOOTING
13-2
Installation problems
If you cannot print over the network, check the following:
1. Make sure that the printer is powered on, is on-line and ready to print.
Verify that the printer and the configuration are good by printing the
configuration page. Refer to the User’s Guide. If the test fails, check:
configuration page. Refer to the User’s Guide. If the test fails, check:
a.
If the LED is not blinking after connected to the network, then the
network firmware settings may be corrupted. Please refer to Step3.
network firmware settings may be corrupted. Please refer to Step3.
b.
In this event, try to restore the factory default settings of the print
server by pressing the TEST switch on the back panel of the printer
for longer than 5 seconds. Once you have done that, switch the
printer off and then on again, and try to print out the configuration
page.
server by pressing the TEST switch on the back panel of the printer
for longer than 5 seconds. Once you have done that, switch the
printer off and then on again, and try to print out the configuration
page.
2. If the configuration page prints but you cannot print documents, try the
following
If none of the following steps are successful, there is almost certainly a hardware
or network problem!