Brother HL-1850 User Guide

CHAPTER 5 BIP INTERNET PRINTING INSTALLATION 

5-6

 

 
Skip this section if you used BRAdmin or a Web Browser to configure the 
remote print server. 
 
As an alternative to BRAdmin, you can use the print server remote console to 
configure the print server. The console can be accessed via TELNET. When you 
access the print server using these utilities, you will be asked for a password. The 
default password is "access". 
 

1.  When you get the "Local>" prompt after connecting to the console, enter 

the command: 

 

SET  POP3  ADDRESS  ipaddress 

 

where ipaddress is the IP address of your POP3 server (consult with your 
network administrator if you do not know this address). 

 
2.  Enter the command: 
 

SET  POP3  NAME  mailboxname  
SET  POP3  PASSWORD  emailpassword

 

 
where mailboxname is the name of the remote print server mailbox and 
emailpassword is the password associated with this mailbox. Usually the 
mailbox name is the same as the first part of the E-mail address that you 
defined previously (for example, usually if the E-mail address is 
emailprinter@xyz.com, then the mailbox name is emailprinter). 

 
3.  The print server is set by default to poll the POP3 server every 30 

seconds. If you wish to change this value, enter the command: 

 

SET  POP3  POLLING  rate 
 
where rate is the polling rate in seconds. 
 
Type EXIT to exit the console and save the changes. You have now 
completed configuring the print server.