Brother Innov-is VE2200 Operating Guide

CHANGING THE EMBROIDERY FOOT

ettin
g R

Basic operations B-43

Position the embroidery foot “W+” with
LED pointer or “W” on the presser foot bar
by aligning the notch of the presser foot to
the large screw.

Side view

Hold the embroidery foot in place with
your right hand, and then use the included
screwdriver to securely tighten the
embroidery foot screw.

→ For users of embroidery foot “W”, skip step

and

go to step

Plug the connector of the embroidery foot
“W+” with LED pointer into the jack on the
back of your machine.

Press

to unlock all keys and

buttons.

→ All keys and operation buttons are unlocked, and

the previous screen is displayed.

■ Checking the Needle Drop Point

With the Embroidery Foot “W+”
with LED Pointer (For Embroidery
foot “W+” with LED pointer user
only)

Before beginning to embroider when using the
embroidery foot “W+” with LED pointer, carefully
read the procedures described in the “Embroidery”
and “Embroidery Edit” chapters.

Press

in the embroidery screen.

→ The LED pointer indicates the needle drop point.

The LED pointer turns off automatically by lowering
the presser foot or returning to the previous page.

CAUTION

• Use the included screwdriver to firmly tighten

the screw of the embroidery foot. If the screw
is loose, the needle may strike the embroidery
foot and possibly cause injury.

Memo

• When the LED pointer is turned on, the

presser foot height is automatically adjusted
according to the fabric thickness.

• If

is pressed again, the fabric thickness

is remeasured and the presser foot is set to
the optimum height.

Note

• With bulky fabrics, the position may not be

accurate due to the various depths of the
fabrics.

• With fabric that has a very uneven surface

such as quilting, the fabric thickness may
not be correctly measured. In this case, the
pointer indication should be used only as a
reference.