Brother NX-250 Leaflet
5
h
Wind a decorative thread around the bobbin
by hand. After winding the bobbin so it is
filled as shown below (about 80%), cut the
thread.
by hand. After winding the bobbin so it is
filled as shown below (about 80%), cut the
thread.
i
Using scissors carefully trim the thread tail as
close to the bobbin as possible.
close to the bobbin as possible.
a
Beginning of wound thread
j
Install the bobbin wound with thread.
Whether or not tension should be applied to the
bobbin thread depends on the type of thread
being used.
bobbin thread depends on the type of thread
being used.
■ When tension is applied to the bobbin
thread
Insert bobbin into bobbin case so the thread unwinds
from the left side.
Then correctly pass the thread through the tension
spring as shown below.
from the left side.
Then correctly pass the thread through the tension
spring as shown below.
a
Tension spring
CAUTION
• Be sure to use the bobbin case (gray) when creating
bobbin work. Using any other bobbin case may
result in the thread becoming tangled or damage to
the machine.
result in the thread becoming tangled or damage to
the machine.
• Make sure that the bobbin case is correctly
installed. If the bobbin case is incorrectly installed,
the thread may become tangled or the machine may
be damaged.
the thread may become tangled or the machine may
be damaged.
CAUTION
• Be sure to use the machine’s included bobbin or one
designed specifically for this machine. Using any
other bobbin may result in damage or injuries.
other bobbin may result in damage or injuries.
Actual size
This model
Other models
Note
• Slowly and evenly wind the thread around the
bobbin.
• For best results, wind the bobbin so the thread is
snug and not twisted.
CAUTION
• If thread extends beyond the top of the bobbin too
much, the thread may become tangled or the
needle may break.
needle may break.
11.5 mm
(approx.
7/16 inch)
CAUTION
• When winding the bobbin, make sure the thread is
not frayed. Sewing with frayed thread may result in
the thread catching on the tension spring of the
bobbin case, the thread becoming tangled or
damage to the machine.
the thread catching on the tension spring of the
bobbin case, the thread becoming tangled or
damage to the machine.
• Do not guide the bobbin thread through the groove
in the needle plate cover, otherwise the lower
threading cannot be done correctly.
threading cannot be done correctly.