Brother PT-D450 User Guide
LABEL PRINTING
36
Adjusting the Label Length
NOTE
• When the cut option is set to [No Cut] or [Chain], it stops in the middle
of printing area after the last label is printed. After [OK to Feed?] is
displayed, press (
displayed, press (
) or (
) to feed the tape. Press (
) to return
to the text entry screen.
• When the cut option is set to [Large Margin], [Small Margin], [Chain],
after printing the message [Cut tape or press Enter to continue.] is
displayed and the P-touch labeler goes into the cut pause mode. By
pressing the Tape cutter lever, you can cut the tape at the position
you set in [Cut Option].
Adjusting the Label Length
When the tape cassette comes to the end, the printed length may be less
accurate.
In this case, you can adjust the label length.
NOTE
Approximately 1 % of the total label length will be adjusted by 1 level.
Special
tape
• Select this setting when
using special tape.
• When using Fabric Iron-On
Tapes or Heat Shrink Tube,
set [Special tape] for [Cut
Option] before printing.
After printing, remove the
tape cassette from the
P-touch labeler and use
scissors to cut the tape.
• When multiple copies are printed one
time:
• When a label is printed two times:
1. 1st print
2. 2nd print
Setting
Description
Example
ABC
ABC
0.94"
(23.9 mm)
0.16"
(4 mm)
0.16"
(4 mm)
ABC
ABC
1
2
0.94"
(23.9 mm)
1.1"
(27.9 mm)
(
)
Î
/
[Settings]
Î
(
) or (
)
Î
/
[Adjustment]
Î
(
) or
(
)
Î
/
[Label
Length]
Î
(
) or (
)
Î
/
[-5 - +5]
Î
(
)
or (
).