Brother PE-DESIGN NEXT Instruction Manual

164

Tutorial 10-2: Creating Design for Multi-Position Hoops

Step 4

Checking the pattern

Click 1.

Check the sewing order of each pattern and
the number of times the hoop position will be
changed.

Only the patterns that would be sewn at the
current position in the hoop installation order
appear in the Design Page, and the
embroidering area for the current hoop
position is outlined in red.

(1) The position in the hoop installation order

for the currently displayed pattern.

(2) To display information for patterns at

other positions in the hoop installation
order, click Previous or Next.

■

Saving the design

The entire design is saved as a single file
(.pes).

■

Writing the design to an original
card

A design for a multi-position hoop is created
by considering the pattern in each hoop
installation position as one pattern, then
combining them.

Therefore, when this type of design is written
to an original card, one multi-position hoop
design is saved as a combination of multiple
patterns.

: This pattern is sewn when the hoop is

installed at the top installation position
(position a).

: This pattern is sewn when the hoop is

installed at the middle installation position
(position b).

: This pattern is sewn when the hoop is

installed at the bottom installation position
(position c).

Therefore, the frame installation position
sewing order for the pattern shown above is b,
a, then c.

Note:

If a pattern is larger than the embroidery
area or if a pattern is positioned so that it
does not completely fit within an embroidery
area, the error message appears. After the
pattern causing the error is displayed, select
the pattern and change its size or position.

(2)

(1)

Memo:

If the file size or the number of color changes
is larger than the specified number, or if one of
the patterns does not completely fit within an
embroidery area, the error message appears.

XE8656-001.book Page 164 Monday, May 24, 2010 5:44 PM