Brother CM550DX/ CM550 Operating Guide
10
The following procedures describe basic operations, from preparing the material to performing trial cutting.
Removing the Transport Packing
Materials
Materials
Before turning on the machine, remove the shipping
tape and the cardboard shock-absorbing material.
tape and the cardboard shock-absorbing material.
Note
•
If the packing materials were removed after the
machine was turned on, turn the machine off,
then on again. Continuing to use the machine
without restarting it may result in incorrect
operation.
machine was turned on, turn the machine off,
then on again. Continuing to use the machine
without restarting it may result in incorrect
operation.
Adjusting the Angle of the Operation
Panel
Panel
The angle of the operation panel can be adjusted to
one of three levels.
one of three levels.
To store away the operation panel, first raise it until it
is vertical, and then it can be lowered and stored
away. If you wish to decrease the angle of the
operation panel, raise it until it is vertical, and then
adjust the angle again.
is vertical, and then it can be lowered and stored
away. If you wish to decrease the angle of the
operation panel, raise it until it is vertical, and then
adjust the angle again.
Note
• Follow the instructions provided above to lower
the panel. Lowering it forcibly may cause
damage to the panel.
damage to the panel.
Turning On/Off the Machine
a
Connect the power cord to the AC adapter, and
then connect the AC adapter to the machine.
then connect the AC adapter to the machine.
a Power cord
b AC adapter
b AC adapter
Memo
• When using the AC adapter, untie the bundled
cord.
b
Plug the power cord into an electrical outlet.
FIRST STEPS
b
a