Brother CM350 Leaflet
1
Specifying an Inside Offset
You can specify at what distance the cut is to be
made from the inside of the pattern outline. This can
be used, for example, to create a sticker that is cut
slightly inside an outline as shown below.
made from the inside of the pattern outline. This can
be used, for example, to create a sticker that is cut
slightly inside an outline as shown below.
a
Touch
in the image trim screen.
• Grayscale recognition mode
• Color recognition mode
X
The setting screen appears.
b
Touch
to change the setting.
Removing Unnecessary Patterns (dots,
lines, etc.)
lines, etc.)
An image scanned using the “Direct Cut” mode can
be cut out after unnecessary patterns (dots, lines,
etc.) have been deleted.
be cut out after unnecessary patterns (dots, lines,
etc.) have been deleted.
a
Touch
in the draw/cut selection screen.
b
Select the pattern to be deleted. For details on
selecting a pattern to be deleted, see “PATTERN
SELECTION” in the Operation Manual.
selecting a pattern to be deleted, see “PATTERN
SELECTION” in the Operation Manual.
X
The selected pattern is surrounded with a red
box.
box.
c
Touch
to delete the selected pattern.
Trial Cutting
Trial cutting can be performed after scanning
material in “Direct Cut” mode. For details on trial
cutting, see “Trial Cutting” in the Operation Manual.
material in “Direct Cut” mode. For details on trial
cutting, see “Trial Cutting” in the Operation Manual.
a
Touch
in the layout editing screen.
Additional Features of “Direct Cut” Mode