Brother CM350R Operating Guide

The following procedures describe basic operations, from preparing the material to performing trial cutting.

Removing the Transport Packing
Materials

Before turning on the machine, remove the shipping
tape and the cardboard shock-absorbing material.

a Shipping tape
b Cardboard shock-absorbing material

Note

•

If the packing materials were removed after the
machine was turned on, turn the machine off,
then on again. Continuing to use the machine
without restarting it may result in incorrect
operation.

Adjusting the Angle of the Operation
Panel

The angle of the operation panel can be adjusted to
one of three levels.

To store away the operation panel, first raise it until it
is vertical, and then it can be lowered and stored
away. If you wish to decrease the angle of the
operation panel, raise it until it is vertical, and then
adjust the angle again.

Note

• Follow the instructions provided above to lower

the panel. Lowering it forcibly may cause
damage to the panel.

Using the Touch Pen and Spatula
Stand (on certain models)

There is a touch pen and spatula stand behind the
operation panel.

a Touch pen and spatula stand

Since the touch pen and spatula can stand in their
holders, they can easily be used, for example, while
cutting. The touch pen and spatula stand can also be
removed and placed in any convenient location.
The touch pen can be stored in its holder when it is
not being used.

FIRST STEPS