Brother CM350H Operating Guide
31
1
Buzzer Sound
Select whether or not an operation sound is
produced, for example, when a key is touched.
produced, for example, when a key is touched.
Seam Allowance
Specify the seam allowance. This is applied when
drawing on fabric, then cutting it, for example, when
making quilt pieces. For details, see “Cutting Around
Drawings” on page 57.
drawing on fabric, then cutting it, for example, when
making quilt pieces. For details, see “Cutting Around
Drawings” on page 57.
Memo
•
When multiple patterns are cut at the same
time, the setting specified in this screen is
applied to all patterns.
time, the setting specified in this screen is
applied to all patterns.
•
If cutting line data saved with a different seam
allowance is imported and used, the setting
specified in this screen will have priority over
the saved setting.
allowance is imported and used, the setting
specified in this screen will have priority over
the saved setting.
Pattern Interval
Specify the spacing between patterns as well as white
space around the edges of cutting area when patterns
in the pattern layout screen are automatically
arranged. The larger the number setting, the further
spacing between patterns.
space around the edges of cutting area when patterns
in the pattern layout screen are automatically
arranged. The larger the number setting, the further
spacing between patterns.
Note
•
Set the number to “3” or higher when
lightweight fabric is attached to the mat with a
high tack adhesive fabric support sheet.
lightweight fabric is attached to the mat with a
high tack adhesive fabric support sheet.
■ Page 4
Opening Screen
Select whether the opening slide show is displayed
after the machine is turned on. If the slide show is
displayed, touch the screen to display the home
screen.
after the machine is turned on. If the slide show is
displayed, touch the screen to display the home
screen.
Scanning/Cutting Position Adjustment
The scanning/cutting position can be adjusted. To
adjust the position, touch
to display the settings
screen. For details, see “Adjusting the Scanning/
Cutting Position” on page 81.
Cutting Position” on page 81.
■ Page 5
No.
Displays the serial number specific for this machine.
Ver.
Displays the version information for this software.
Machine Information
Touch
, this page displays machine information.
■ Page 6 (Wireless network models
only)
Network
Touch
to set up a wireless network. For details,
refer to “Wireless Network Setup Guide”.
■ Page 7 (Wireless network models
only)
ScanNCut Online
Touch the “Register” key to set up ScanNCut Online.
For details, refer to “Wireless Network Setup Guide”.
For details, refer to “Wireless Network Setup Guide”.