Samsung FSR-14 User Manual

English - 17

SETTING

When moving your refrigerator

To prevent floor damage, be sure the front leveling

legs are in the up position (above the floor).
Refer to “How to level the refrigerator” in the

manual on page 22.

Screw Driver

Leg

Flooring

For proper installation, you must place this

refrigerator on a level, hard surface that is the same

height as the rest of the floor.

This surface should be strong enough to support a

fully loaded refrigerator.

To protect the finish of the flooring, cut a large

section of the cardboard carton and place it under

the refrigerator where you are working.

When moving the refrigerator, you need to pull and

push it straight forwards or back.

Do not wiggle it from side to side.

Required Tools (Not provided)

Philips screwdriver

(+)

Flat-blade screw

driver (-)

Socket wrench

10 mm

Allen wrench

5 mm

SETTING UP THE REFRIGERATOR

Now that you have your new Refrigerator installed

in place, you are ready to set up and enjoy the

features and functions of the appliance.

By completing the following steps, your Refrigerator

should be fully operational.

If not, first check the power supply and electricity

source or try the troubleshooting section at the

back of this user’s guide.

If you have any further questions, contact your

Samsung Electronics service centre.

1. Place the Refrigerator in an appropriate location

with reasonable clearance between the wall and

the Refrigerator.

Refer to installation instructions in this manual.

2. Once the Refrigerator is plugged in, make sure

the interior light comes on when you open the

doors.

3. Set the Temperature control to the coldest

temperature and wait for an hour.

The Freezer will get slightly chilled and the

motor will run smoothly.

4. After powering the Refrigerator, it will take a few

hours to reach the appropriate temperature.

You can store food and drinks in the Refrigerator

after the temperature is sufficiently cool.

5. Once installation is complete, press the

dispenser lever to check if the water or the ice

is properly dispensed.

6. Make sure the front side of the refrigerator is 0.6

degree higher than its rear side.

DA68-02976R-00.indb 17

2016. 8. 1. �� 10:51